![]() ![]() Important things: Green circle- the two knobs we'd like to convert to one for a stand up shower. Would it be better just to cut the drain line back to main drain line and run new shower drain?Ģ) Since we're converting from tub to shower, we don't need the overflow drain cover anymore (the thing that you can push or pull and it stops up your drain so you can take a bath) can we just cap that section? I'm worried about venting, per this link: ģ) Is there an easy (no soldering) way to convert two faucet handles (hot & cold) into one shower faucet handle? But upon looking at the existing plumbing I have a few questions.ġ) Per this link: it looks like we can't re-use the same drain line for the shower as we have in the tub (We're in Indiana not California but I'm not sure if that makes a difference). The tub is out, the walls are open, we have the stand up shower kit bought. Plus, it is more likely to malfunction thanks to all the mechanical parts.I'm in the middle of a tub to shower conversion but am a complete amateur when it comes to plumbing issues. Installation is not as easy as the others because the connecting linkage is fitted inside the overflow pipe. This type of stopper is the most complicated to clean because the rocker arm and stopper need to be removed through the drain opening and the connecting rod linkage extracts through the overflow plate.Īnd thanks to the complicated design, it is more likely to trap hairs and debris, which leads to stopper malfunctions. At the bottom of the connecting rod is a spring that activates to move the plug. When you move the lever, the linkage pivots a rocker arm that lifts a pop-up stopper. ![]() The lever connects with the stopper via a series of rod linkages in the overflow drainpipe that move when you operate the lever. The pop-up stopper resembles a bathroom sink stopper because it has a lever located on the overflow plate. More expensive to buy compared to other drain stoppers.Tricky to install, so you may need a professional.Thanks to its simple mechanical design, it rarely malfunctions, and getting access to the drain to clean it, unblock it and remove debris is easy because the setscrew just unscrews from the thread. The setscrew sits beneath the stopper top cap and can be fiddly to remove if it is overtightened or left unopened for some time. This drain stopper has a center set screw that winds into the threaded drain crossbar. As you turn it one way, the stopper goes down and shuts, and the other, it lifts and opens. This kind of drain stopper has a small knob on the top of the cap that you can twist and turn to open and close the drain. Let’s take a look at each one in more detail. There are 6 commonly used types of drain stoppers: lift-and-turn, push-and-pull, pop-up, toe-touch, flip-it, and trip lever. Trip lever and pop-up stoppers are more complicated to install and clean, but offer different benefits like concealed mechanisms and familiar styles.Toe-touch stoppers work with a spring-loaded mechanism, while flip-it stoppers don’t require any tools for installation.Lift-and-turn and push-and-pull stoppers are easy to clean and rarely malfunction, but can be tricky to remove due to the setscrew. ![]() There are 6 types of bathtub drain stoppers: lift-and-turn, push-and-pull, pop-up, toe-touch, flip-it, and trip lever.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |